Nous sommes clairs que ce soit necessaire d'avoir quelques certificats IT dans cette industrie de plus en plus intense. Le Certificat IT est une bonne examination des connaissances démandées. Dans l'Industrie IT, le test HP HP0-144 est une bonne examination. Mais c'est difficile à passer le test HP HP0-144. Pour améliorer le travail dans le future, c'est intélligent de prendre une bonne formation en coûtant un peu d'argent. Vous allez passer le test 100% en utilisant le Pass4Test. Votre argent sera tout rendu si votre test est raté.
Participer au test HP HP0-144 est un bon choix, parce que dans l'Industire IT, beaucoup de gens tirent un point de vue que le Certificat HP HP0-144 symbole bien la professionnalité d'un travailleur dans cette industrie.
Les produits de Pass4Test sont préparés pour le test Certification HP HP0-144, y compris les formations et les informations ciblées au test HP HP0-144. D'ailleurs, la Q&A de Pass4Test qui est impressionnée par la grande couverture des questions et la haute précision des réponses vous permet à réussir le test avec une haute note.
Code d'Examen: HP0-144
Nom d'Examen: HP (ProCurve Secure WAN)
Questions et réponses: 111 Q&As
Après une longue attente, les documentations de test HP HP0-144 qui combinent tous les efforts des experts de Pas4Test sont finalement sorties. Les documentations de Pass4Test sont bien répandues pendant les candidats. L'outil de formation est réputée par sa haute précision et grade couverture des questions, d'ailleurs, il est bien proche que test réel. Vous pouvez réussir le test HP HP0-144 à la première fois.
Pass4Test vous offre un choix meilleur pour faire votre préparation de test HP HP0-144 plus éfficace. Si vous voulez réussir le test plus tôt, il ne faut que ajouter la Q&A de HP HP0-144 à votre cahier. Pass4Test serait votre guide pendant la préparation et vous permet à réussir le test HP HP0-144 sans aucun doute. Vous pouvez obtenir le Certificat comme vous voulez.
Le programme de formation HP HP0-144 offert par Pass4Test comprend les exercices et les test simulation. Vous voyez aussi les autres sites d'offrir l'outil de formation, mais c'est pas difficile à découvrir une grand écart de la qualité entre Pass4Test et les autres fournisseurs. Celui de Pass4Test est plus complet et convenable pour la préparation dans une courte terme.
Pass4Test est un fournisseur important de résume du test Certification IT dans tous les fournissurs. Les experts de Pass4Test travaillent sans arrêt juste pour augmenter la qualité de l'outil formation et vous aider à économiser le temps et l'argent. D'ailleur, le servie en ligne après vendre est toujours disponible pour vous.
HP0-144 Démo gratuit à télécharger: http://www.pass4test.fr/HP0-144.html
NO.1 Which feature does the ProCurve Secure Router 7203dl provide that the ProCurve Secure Router
7102dl does not?
A. built-in encryption module
B. support for redundant power source (RPS)
C. one additional Ethernet port
D. support for up to 6 ADSL lines
Answer: B
certification HP HP0-144 HP0-144
NO.2 Which steps must you complete to enable access to the ProCurve Secure Router's web interface?
Select TWO.
A. Enable the ftp server.
B. Enable the http server.
C. Configure a Telnet password.
D. Configure an enable mode password.
E. Configure a username and password.
F. Configure an ACL permitting FTP traffic.
Answer: BE
certification HP certification HP0-144 certification HP0-144 certification HP0-144 HP0-144 certification HP0-144
NO.3 What determines the number of Asynchronous Transfer Mode (ATM) subinterfaces you configure for
an Asymmetric Digital Subscriber Line (ADSL) connection?
A. the number of LANs you want to connect to the Internet
B. the number of access control lists (ACLs) you want to apply to the ADSL interface
C. the amount of bandwidth you want to reserve for upstream and downstream transmissions
D. the number of virtual circuits you want to establish
Answer: D
HP HP0-144 examen HP0-144 examen certification HP0-144
NO.4 How many access control lists (ACLs) can you apply directly to one interface?
A. 1
B. 2
C. 5
D. unlimited number
Answer: B
certification HP certification HP0-144 HP0-144 examen certification HP0-144
NO.5 Which command allows you to use enable mode commands from any mode except basic mode?
A. the get command
B. the go command
C. the nomode command
D. the do command
Answer: D
HP HP0-144 examen HP0-144 HP0-144 certification HP0-144
NO.6 How can you configure the ProCurve Secure Router so that a backup module does not establish a
backup connection with an unauthenticated peer?
A. Set the backup call mode so that the module cannot answer calls until the primary connection goes
down.
B. Configure PAP or CHAP on the backup interface.
C. Add an authentication, authorization, and accounting (AAA) list to the backup interface.
D. Add authenticated routers' hostnames to the global configuration mode database.
Answer: B
HP certification HP0-144 HP0-144 HP0-144 HP0-144
NO.7 Which tasks can you use CompactFlash to complete? Select TWO.
A. Configure routers at remote sites.
B. Increase RAM on the router by configuring virtual memory.
C. Enter bootstrap mode.
D. Back up configuration files.
E. Enable IPSec security.
F. Store and view the Secure Router OS in an uncompressed format.
Answer: AD
certification HP HP0-144 HP0-144 HP0-144
NO.8 Which interfaces can be configured as DHCP clients? Select TWO.
A. BRI interface
B. ADSL interface
C. ATM subinterface
D. Ethernet interface
E. Frame Relay interface
F. DSX-1 or G. 703 interface
Answer: CD
HP HP0-144 examen HP0-144
NO.9 The Asymmetric Digital Subscriber Line (ADSL) keeps going into training mode. What is causing this
problem?
A. The signaling type configured for the router does not match the signaling type used by the service
provider.
B. The encapsulation type configured for the router does not match the type used by the service provider.
C. The signal-to-noise (SNR) margin configured for the router is too high.
D. The ADSL interface has not been assigned an IP address.
Answer: C
HP examen HP0-144 examen HP0-144
NO.10 Which Quality of Service (QoS) features does the ProCurve Secure Router support? Select TWO.
A. custom queuing
B. low latency queuing (LLQ)
C. weighted fair queuing (WFQ)
D. generic traffic shaping (GTS)
E. Frame Relay traffic shaping (FRTS)
Answer: BC
certification HP HP0-144 HP0-144 examen
NO.11 What must you do to configure Point-to-Point Protocol over Ethernet (PPPoE) for an Asymmetric
Digital Subscriber Line (ADSL)?
A. Configure and bind the ATM interface to the ADSL interface; then bind the ATM subinterface to a PPP
interface.
B. Configure a PPP interface; then bind the PPP interface to the ADSL interface.
C. Configure both an ATM interface and a PPP interface, and bind the ADSL interface to both virtual
interfaces.
D. Configure a PPPoE interface and bind it directly to the ADSL interface.
Answer: A
certification HP certification HP0-144 HP0-144 HP0-144 examen
NO.12 Which type of firewall monitors traffic on several layers of the Open Systems Interconnection (OSI)
model?
A. packet-filtering firewall
B. circuit-level gateway
C. application-level gateway
D. stateful-inspection firewall
Answer: D
HP examen HP0-144 examen certification HP0-144 HP0-144 certification HP0-144 HP0-144
NO.13 You have configured an Integrated Services Digital Network (ISDN) backup for your organization's
Frame Relay connection. When this connection goes down, which virtual interface could establish and
maintain the backup connection?
A. a backup Asynchronous Transfer Mode (ATM) interface
B. a backup Frame Relay interface
C. a backup Point-to-Point Protocol (PPP) interface
D. a backup BRI ISDN interface
Answer: C
HP HP0-144 certification HP0-144 HP0-144 HP0-144 certification HP0-144
NO.14 Before the ProCurve Secure Router and the DSL Access Multiplexer (DSLAM) exchange
Asynchronous Transfer Mode (ATM) cells, they utilize physical-layer signaling to establish an Asymmetric
DSL (ADSL) connection. Which monitor evaluates the signal-to-noise ratio (SNR) margin while the router
and the DSLAM establish the physical ADSL connection?
A. ADSL monitor
B. showtime monitor
C. phase 1 monitor
D. training monitor
Answer: D
HP examen HP0-144 HP0-144 examen HP0-144 examen certification HP0-144
NO.15 What is a disadvantage of dynamic routing?
A. Dynamic routing does not allow you to restrict which networks are included in routing tables.
B. Dynamic routing can consume bandwidth and CPU processes on the router.
C. Dynamic routing is less scalable than static routing.
D. Dynamic routing makes adding new networks to a WAN difficult.
Answer: B
HP examen certification HP0-144 HP0-144 HP0-144 examen certification HP0-144
NO.16 When you are configuring an Asymmetric Digital Subscriber Line (ADSL), what is the purpose of
training mode?
A. ADSL is dependent upon line quality; ADSL devices must determine the best way to use the line.
B. ADSL devices always negotiate the signaling standard used, based on the type of DSLAM used by the
public carrier.
C. The ADSL device and the DSLAM must identify the fastest switched virtual circuit (SVC) available.
D. The training mode is essentially a testing phase to determine if the ADSL module itself is working
correctly.
Answer: A
HP HP0-144 HP0-144 HP0-144
NO.17 Which type of connection may be used for the backup modules on the ProCurve Secure Router?
A. Asymmetric Digital Subscriber Line (ADSL)2+, Annex A or Annex B
B. T1 or E1 connections
C. Integrated Services Digital Network (ISDN) connection
D. Asynchronous Transfer Mode (ATM) connection
Answer: C
HP HP0-144 HP0-144 HP0-144 HP0-144 HP0-144 examen
NO.18 Click the Exhibit button.
You want your ProCurve Secure Router to act as a gateway device for any remote VPN client who
initiates IKE in its most secure mode. Which policy shown contains the correct configurations for this
use?
A. 1
B. 2
C. 3
D. 4
E. 5
F. 6
G. 7
Answer: C
HP examen certification HP0-144 certification HP0-144 HP0-144 examen
NO.19 Which function does the virtual path identifier/virtual channel identifier (VPI/VCI) perform?
A. It identifies the endpoint for an Asynchronous Transfer Mode (ATM) connection.
B. It identifies the tunnel endpoint for virtual private network (VPN) peers.
C. It identifies the permanent virtual circuit (PVC) in a Frame Relay network.
D. It defines each peer in a Point-to-Point Protocol (PPP) connection, if authentication is configured.
Answer: A
certification HP HP0-144 certification HP0-144
NO.20 The status of the BRI interface is "connected." What does a connected status indicate?
A. The backup module is installed in the ProCurve Secure Router and is ready to be configured.
B. The BRI interface has been assigned to a primary connection.
C. The BRI interface is ready to provide a backup connection.
D. The BRI interface is currently providing a backup connection.
Answer: D
certification HP HP0-144 HP0-144 certification HP0-144 HP0-144 HP0-144
Le temps est tellement précieux dans cette société que une bonn façon de se former avant le test HP HP0-144 est très important. Pass4Test fait tous efforts à assurer tous les candidats à réussir le test. Aussi, un an de mise à jour est gratuite pour vous. Si vous ne passez pas le test, votre argent sera tout rendu.
没有评论:
发表评论